This platform is meant only for use with the included inset, which is an extension of the platform that fits inside a power rack.
This platform is made for doing cleans, snatches and deadlifts. Using a high quality lifting platform means that users are lifting on a perfectly flat and safe surface. The increase in confidence that provides means that it's only a matter of lifting the weight that's holding them back.
6 Coats of Polyurethane - Maximum protection of the oak and logo, along with a smooth but non-slippery surface.
12-Gauge Steel Frame - This surrounds the sides of the platform to keep the edges from being damaged. The rear portion of the platform where the inset fits is not framed.
19mm thick, 41" wide Solid Red Oak covers a 25mm MDF board. The two layers sandwich a membrane between them, minimizing the chance of warping.
27" wide Rubber Matting is laid flush with the oak on both sides.
Size - All platforms are 8ft wide, so it's only a question of length. 8ft long is the best so that you have plenty of room to drop the weight in front of and behind you. But if you're tight on space, the 6ft works too. The 4ft is fine for deadlifts.
Custom Logo - Your logo is applied prior to varnishing. If you don't want a custom logo, the York Barbell logo will be applied as pictured.
Ramp - Roll your bench on and off the platform with ease.
An inset is included. It's the piece that extends the platform to fit inside your rack.
#54250 - For use with York STS Multi-Function Rack, STS Power Rack and STS Triple Combo Rack.
#54252 - For use with York STS Half Rack.
#54253 - For use with Double Half Rack and STS Triple Combo Rack.
(For the York STS Triple Combo Rack you'll want to buy two platforms, one with the #54250 inset and one with the #54253 inset)